Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| s16setup [2025/02/18 20:59] – msebborn | s16setup [2025/02/18 21:02] (current) – msebborn |
|---|
| |5|Ensure that the X32 is set as the Master unit. Go to "Setup" by pressing the "Setup" button, and make sure you are on "Global" page. Make sure that "Internal" is selected.|{{::x32-global.jpg?600|}} | | |5|Ensure that the X32 is set as the Master unit. Go to "Setup" by pressing the "Setup" button, and make sure you are on "Global" page. Make sure that "Internal" is selected.|{{::x32-global.jpg?600|}} | |
| |6|Make sure the S16 is set to be a slave unit, and not the master. Check that the display shows "In 1"- if not, press and hold the "Config" button and turn the "HA Control" knob until "1-8" is shown.\\ A green LED will illuminate on the S16 and a Green signal will appear on the X32 screen if the link is working, If not, try this again. |{{::s16setup.jpg?400|}} | | |6|Make sure the S16 is set to be a slave unit, and not the master. Check that the display shows "In 1"- if not, press and hold the "Config" button and turn the "HA Control" knob until "1-8" is shown.\\ A green LED will illuminate on the S16 and a Green signal will appear on the X32 screen if the link is working, If not, try this again. |{{::s16setup.jpg?400|}} | |
| |7|On the X32, select the [[routing-screen|Routing]] screen, make sure you are on the first page (Input) and then set "1-8" to "AES50 A1-8" and 9-16 to "AES50 A9-16". \\ Scroll down on under 1-8 to AES A1-8, and scroll down under 9-16 to AES A9-16 as shown on the screen.|{{::input_screen.png?600|}} | | |7|On the X32, select the [[routing-screen|Routing]] screen, make sure you are on the first page (Input) and then set "1-8" to "AES50 A1-8" and 9-16 to "AES50 A9-16". \\ Scroll down under 1-8 to AES A1-8, and scroll down under 9-16 to AES A9-16 as shown on the image of the screen.|{{::input_screen.png?600|}} | |
| |8|Scroll across to the Out page. Set "Output 7" to "Main L" and "Output 8" to "Main R"| | | |8|Scroll across to the Out page. Set "Output 7" to "Main L" and "Output 8" to "Main R"| | |
| |
| |
