Differences

This shows you the differences between two versions of the page.

--- operating [2025/02/18 22:00] – [Gain settings] msebborn
+++ operating [2026/04/24 10:32] (current) – [Adding Effects] msebborn
@@ Line 18: / Line 18: @@
 Connect the inputs to the X32 Desk / S16 Snake, plus main and monitor speakers.  [[suggestedSetup|Suggested Setup]]
+Set the master volume - on Panel B marked MAIN
 ==== Display setup ====
@@ Line 60: / Line 61: @@
 |5|Repeat for all other inputs| |
-Note: During this stage, you can select which channels need Phantom Power - press the 48V button to switch it on (button illuminates when on). The "O" button is used to invert the phase of  amicrophone
+Note: During this stage, you can select which channels need Phantom Power - press the 48V button to switch it on (button illuminates when on).
+The "O" button is used to invert the phase of a microphone - this is only really necessary when two mics are picking up the same item, and one mic is out of phase causing the sound to be reduced.
 ==== EQ Settings ====
@@ Line 101: / Line 104: @@
   * Unselect the "Mute Group" button
+==== Setting the Monitor Mix ====
+Enable the MixBus channels that are to be used for monitors - in panel B set the volume level for used MixBus channel.  Configure the display as required.
+Then select the Input channel on panel A and then using the Bus Sends panel, dial in the amount of sound to be sent to each of the monitors, eg channel 1 (microphone), dial lots into the performers own monitor and some to suit into the other monitor channels.